Facet Go-No-Go Military Monitor Cartridge 2 in.

Maximum water removal, solids holding capacity and shutdown protection assures clean, dry fuel

The Facet 2" (51 mm.) nominal outside diameter GNG Series Go-No-Go monitor cartridges perform three jobs - they absorb free and emulsified water to less than 2 ppm; remove ultra-fine solids even when surfactants and fuel additives are present; and shut down system flow when hit with a localized slug of water, giving you clean, dry fuel. The GNG Series Go- No-Go monitor cartridges are designed to flow from the outside to inside at a rate of 1 gallon (3.79 liters) per inch of length.

Go-No-Go monitor cartridges meet the latest edition of Military Specification MIL-M-81380C(AS) for Monitor, Contamination, Aviation Fuel Dispensing Systems.

The presence of water or solids in the incoming fuel will be indicated by an increase in the pressure differential or a decrease in the flow rate as the cartridges reach their maximum capacity for solids, water or a combination of both. When either happens, the cartridges should be replaced.

Each GNG Series Go-No-Go monitor cartridge is constructed of various water absorbent media, plus fine filtration layers wrapped around a molded center tube for balanced flow and structural strength - all encased in a protective outer sock material. The end cap material is of injection molded, glass-filled nylon which provides superior strength and ease of maintenance. This material gives excellent support for the o-ring on the mounting/adaptor end.

Features

• Tested and qualified to meet the latest edition of Military Specification (MIL-M-81380C(AS)) for Monitor, Contanimantion, Aviation Fuel Dispensing Systems
• New conductive end caps with anti-static properties which greatly reduce the possibility of static discharge during the fueling process
• Multi-layered media for increased solids holding, water removal and shutdown protection
• Structurally withstands a minimum of 150 psid
• Less than 0.3 mg/liter of solids in effluent
• Less than 2 ppm of water in effluent
• Nitrile rubber gaskets
• Not adversely affected by exposure to temperatures varying from -65° F to 160° F
• Works in the presence of srfactants and fuel additives

Specifications

• Min. Structurally withstand pressure: 150 psid
• Flow direction: outside to inside
• Flow rate per in. of length: 1 gal. (3.79 lit)
• Standard gasket material: Nitrile rubber
• End caps: Glass-filled nylon
• Nominal length: 15 7/8 in. (400 mm)
• OD: 1 3/4 in. (44 mm)
• ID: 7/8 in. (29 mm)