The Facet 5 in. (127 mm) nominal outside diameter FG Series Fuel-Gard monitor cartridges perform three jobs, they absorb free and emulsified water, remove ultra-fine solids and shut down system flow when hit with a localized slug of water, giving you clean, dry fuel. The FG Series Fuel-Gard monitor cartridges are designed to flow from the outside to inside at a rate of 1 gpm (3.79 lpm) per inch of length.
Fuel-Gard monitor cartridges meet the 7th edition of El 1583 Specification - Laboratory Test and Minimum Performance Levels for Aviation Fuel Filter Monitors.
The presence of water or solids in the incoming fuel will be indicated by an increase in the pressure differential or a decrease in the flow rate as the cartridges reach their maximum capacity for solids, water or a combination of both. When either happens, the cartridges should be replaced.
Each FG Series Fuel-Gard monitor cartridge is constructed of various water absorbent media, plus fine filtration layers pleated to give you long life. The perforated metal center tube provides for balanced flow and structural strength. The center tube supports both the pleated section and absorbent media when hit with a localized slug of water.
The outer shell retains the media during and after shutdown.
Note: Monitor cartridges should never be used with fuels containing anti-icing additives such as FSII, PRIST, and DI-EGME. This includes pre-mixed and military fuels containing these additives. The use of monitor cartridges with fuels containing anti-icing additives may result in (1) a failure of the monitor cartridge and/or (2) migration of filtration media into the fuel stream, either of which could potentially cause damage to or sudden failure of the corresponding engine. The supplier shall not be liable in any respect for any damage or loss that arises from the use of monitor cartridges with fuels containing anti-icing additives. Such use is entirely at the user's risk.
Features
- Tested and qualified to meet the 7th edition of El 1583 specification - Laboratory Test and Minimum Performance Levels and Aviation Fuel Filter Monitors
- Multi-layered media for increased solids holding, water removal and shutdown protection
- All metal components are treated against corrosion
- Structurally withstands a minimum of 174 psid (12 bar)
- Heavy duty metal center tube and outer shell for extra structural strength
- Nitrile rubber gaskets
- Not adversely affected by exposure to temperatures varying from -65° F to 160° F (-54° C to 71° C)
Specifications
- O.D.: 5 in. (152 mm)
- Length: 12 in. (305 mm)
- End cap material: Injection molded, glass filled nylon
