Dixon Brass Female NPSM Swivel Push-On Hose Barb Fittings w/Ball Seat

SKU:
Please choose an option below
Manufacturer:
Dixon
Product Type:
Female NPSM Swivel x Push-On Hose Barb
Material:
Brass
Weight:
0.03 LBS
$3.12 - $9.87
WARNING: This product may contain a chemical known to the State of California to cause cancer & reproductive harm. For more information, go to www.P65Warnings.ca.gov.
The image shown is for illustration purposes only. The actual product may vary.
Adding to cart… The item has been added

Dixon push-on hose barb fittings are intended for use with Lok-On/push-on style hoses only. No hose clamps or ferrules are needed. Full size range from 1/4 in. hose through 3/4 in. hose.

Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.

Features

  • Compatible hoses: Eaton Aeroquip: 2556, 2565, 2575, FC647, and FS332/ Eaton Weather head: H100, H101, and H201/ Gates: LOL, Python/ Goodyear: Auto grip, Insta-Grip, and Ultra-Grip/ Parker Hannifin: 801, 804, 821, 831, 836, and B7
  • Applications: Pneumatic service, Most fluids, low-pressure hydraulics, and non-potable water service

Specifications

  • Female pipe push-on hose fitting
  • Ball Seat construction
  • Pressure rating: 350 PSI
  • Brass alloy 360
  • Yellow plastic cap
  • Operating temperature: -40° to 150° F ( -40° to 65° C)
  • Do not use worm gear hose clamps or crimped ferrules
  • Approval: SAE J476, J512, J514 and J516
Part #Size#of BarbsBarb Length
2780402C 1/8 in. x 1/4 in. 2 0.77 in.
2780404C 1/4 in. x 1/4 in. 2 0.77 in.
2780604C 1/4 in. x 3/8 in. 2 0.77 in.
2780606C 3/8 in. x 3/8 in. 2 0.92 in.
2780808C 1/2 in. x 1/2 in. 2 1.02 in.
2780812C 3/4 in. x 1/2 in. 2 1.02 in.
2871212C 3/4 in. x 3/4 in. 3 1.50 in.

Instructions

Assembly
  • (1) Trim hose end with smooth square cut
  • (2) Lubricate either push-on fitting or hose, or both
  • (3) Insert push-on fitting into hose until the first barb in in hose
  • (4) Place end of fitting against a flat object and grip the hose 1 inch from the end. Push with a steady force until end of hose is covered by yellow plastic cap.
Disassembly
  • (1) Leave push-on fitting in place and make a 1 in. cut in the hose along the barbed end of the fitting. Be careful not to nick barbs when cutting the hose.
  • (2) With a firm grip on the hose, give a sharp downward pull to release the fitting from the hose.

Downloads

Data Sheet (PDF Download)

Catalog Page (PDF Download)

MSDS (PDF Download)