Graco Husky 716 3/4 in. NPT Stainless Steel Air Diaphragm Pump w/ PTFE Diaphragms & Balls, Acetal Seats

AODD pumps with 3/4 inch (19.05 mm) connection available in aluminum and stainless steel. The Husky 3/4-inch pneumatic positive displacement double diaphragm pumps have an external controller for remote control capabilities.

Graco recommends the installation of a fluid pressure relief valve at the pump outlet to prevent overpressurization and rupture of the pump or hose. Use Fluid Pressure Relief Kit part number GR238428 for 716 aluminum Diaphragm Pumps.

Graco Husky Fluid Kits include the O-rings, Seats, Balls & Diaphragms for the specific materials in your diaphragm pump and can be found in our Parts Department.

Looking for replacement parts? Click here!

Materials Guide

Acetal - For seals balls & wetted body parts

• Wide range of solvent resistance
• Withstands extreme fatigue
• Good level of abrasion resistance
• Groundable for use with flammables
• Not for use with acids or bases

Aluminum - For air motor & wetted body parts

• Medium corrosion & abrasion resistance
• Not for use with HHC's

Nitrile Rubber - For seats, balls & diaphragms

• Good for petroleum based fluids
• Not for use with chemicals
• Food grade

Polypropylene - For air motor, wetted body parts, seats & balls

• Wide chemical compatibility
• General purpose
• Inexpensive alternative

PTFE - For balls & diaphragms

• Excellent for solvents
• Poor abrasion resistance
• Widest chemical compatibility with fluids

Santoprene - For seats, balls & diaphragms

• Good abrasion & chemical resistance
• Not for use with solvents
• Often substituted for EPDM or EPR
• Food grade

Stainless Steel - For air motor, wetted body parts, seats & balls

• High level of corrosion & abrasion resistance
• Passivated for use with water base coatings

Features

• 3/4 in (19.05 mm) fluid inlet & outlet
• No seals to leak or fail
• Quiet running less than 85 dba with easy-to-use remote muffler capability for even lower noise levels
• Easy-to-service air valve and ball checks

Specifications

• Husky 716 series
• Pneumatic diaphragm pump
• 1/4 in. FNPT air inlet
• Fluid inlet & outlet: 3/4 FNPT
• Ball/Diaphragm/Manifold O-Ring: PTFE
• Center Section: Polypropylene
• Seat: Acetal
• Body & Fluid Section: Stainless Steel
• Max air pressure: 100 PSi, 7 bar, 0.69 MPa
• Max air Consumption: 28 SCFM
• Max Flow Rate: 16 GPM
• Max Pump speed: 400 CPM
• Max. Suction lift: 11 Ft. (3.4 m) dry
• Max Solid Size: 0.09 in. (2.5 mm)
• Operating Temperature: 40°F to 225°F ( 4° C to 107°C)
• Standards met: ATEX, CE

Compatible Material

• Antifreeze
• Detergents
• Motor Oil
• Grease & Oil
• Hydraulic Fluid
• Cutting Oil
• Water- Wastewater Treatment
• Water
• Ink