Dixon Stainless Steel Male NPT Push-On Hose Barb Fittings

Dixon push-on hose barb fittings are intended for use with Lok-On/push-on style hoses only. No hose clamps or ferrules are needed and the Swivel is for assembly convenience only, not for live swivel applications. Full size range from 1/4” hose through 3/4” hose.

Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.

Features

• Stainless steel - substantial (>40%) vs. competitors
• Compatible hoses: Eaton Aeroquip: 2556, 2565, 2575, FC647, and FS332/ Eaton Weather head: H100, H101, and H201/ Gates: LOL, Python/ Goodyear: Auto grip, Insta-Grip, and Ultra-Grip/ Parker Hannifin: 801, 804, 821, 831, 836, and B7

Applications

• Pneumatic service
• Most fluids
• Low pressure hydraulics
• Non-potable water service

Specifications

• Male pipe push-on fitting
• Dryseal construction
• Pressure rating: 350 PSI
• 303 Stainless Steel
• Plastic yellow cap
• Operating temperature: -40° to 150° F ( -40° to 65° C)
• Do not use worm gear hose clamps or crimped ferrules
• Approval: SAE J476, J512, J514 and J516

• (1) Trim hose end with smooth square cut
• (2) Lubricate either push-on fitting or hose, or both
• (3) Insert push-on fitting into hose until the first barb in in hose
• (4) Place end of fitting against a flat object and grip the honse 1 inch from the end. Push with a steady force until end of hose is covered by yellow plastic cap.

• (1) Leave push-on fitting in place and make a 1 in. cut in the hose along the barbed end of the fitting. Be careful not to nick barbs when cutting the hose.
• (2) With a firm grip on the hose, give a sharp downward pull to release the fitting from the hose.

Downloads

Data Sheet (PDF Download)

Catalog Page (PDF Download)

MSDS (PDF Download)