RDS Manufacturing 45 Gallon Aluminum Rectangular/Vertical Transfer Fuel Tanks are made in the USA and are DOT approved for transferring diesel fuel and gasoline. These tanks have fully welded seams and are 100% pressure tested before leaving the manufacturer. Aluminum tanks do not rust, protecting fuel from contamination. The tank comes with a GPI HP-100 pump with 8 ft. of dispensing hose, a thermoplastic nozzle and suction tube. The pump is capable of pumping up to 50 gallons per 100 strokes.
Features
- 2 in. female pipe thread coupling for pump
- 0.125 in. heavy-duty aluminum construction - No rusting
- Fully welded seams
- 100% pressure tested
- Built-in baffles reduce sloshing
- Lockable gas cap
- Rollover safety valve (vent)
- Includes 3/8 in. FTP drain plug
- DOT approved tank can be used to transport diesel or gasoline
Specifications
- Material:
- Lightweight, die-cast aluminum housing.
- Stainless steel piston shaft and liner.
- Buna-N seals.
- Built-in air valve to prevent leakage at the nozzle.
- Non-UL Model:
- 3/4 in. x 8 ft. Buna-N hose.
- Thermoplastic unleaded nozzle.
- Built-in nozzle holder.
- UL Model:
- UL Model:3/4 in. x 8 ft. Electrically Conductive hose (UL Listed) with metal nozzle.
- Suction Pipe: Plastic, adjustable 22 to 40 in.
- Pumping Capacity: 1/2 gallon (1.9 litres) per stroke cycle.
- Inlet: 1 in. NPT
- Outlet: 3/4 in. NPT
- Shipping Weight: 14 lbs.
- Hose and Nozzle:
- Pumping Settings: 1/2 gallon setting for high volume, high resistance. 1/4 gallon setting for low volume, low resistance.
- Pumping Settings: 1/2 gallon setting for high volume, high resistance.
- 1/4 gallon setting for low volume, low resistance.
Important Notes:
- Mounting tabs extend out 1 in. - adds 2 in. to total length and 1 in. to total width
- Add 2 1/2 in. for fill cap height
- Always measure the truck's bed for clearance at corners, wheel wells, etc.
